Apply the Headset

NOTE: The test protocol should be downloaded into the HCU prior to applying the Headset on a subject.

Before placing the Headset on the patient's head:

Take note of your patient's hair type, if hair is curly or long, or if the patient has a side-part, then part the hair down the middle BEFORE applying the headset
Loosen the Backstrap (see Harness) but do not disconnect the snaps
Loosen both sides of the Chinstrap and unsnap one side.

Place the Harness on the patient's head as centered as possible.

Snap both sides of the Chinstrap.

Top

The Earpiece should be approximately 1/4 inch above where the ear connects to the head.

Make sure the Mastoid Pods are directly over the mastoid bones.

Center the Forehead Pod 2 finger breadths above the browline.

Tighten the Backstrap to bring the Electronics Module in contact with the head.

Readjust the straps to ensure that the chin is centered in the Chinstrap (the chin should poke through the hole in the center of the chinstrap)

Adjust straps on both sides to center the ear in the Earpieces. This is done while pulling the Earpieces down around the patient's ears.